Hypex DIY Class D Connection material DSP to Ncore signal cable

50cm balanced signal cable with 4-pin connectors on both sides to connect our DLCP to our Ncore modules also providing the enable signal.

Specifications

The QuietConduit cable design incorporates several refinements over normal balanced cables.
A conductive polymer interface layer between the braid shield and the insulation of the signal conductor short-circuits
triboelectric currents where they are generating, virtually eliminating microphonic noise pickup.
A secondary benefit of this layer is to improve the electrostatic shielding effectiveness of the braid shield.
Another crucial improvement is the elimination of drain wires, which is normally included for ease of termination
but which allow shield currents to couple noise asymmetrically into the signal conductors. The geometry of the
QuietConduit cable is precisely controlled, insuring that any noise coupling is strictly limited to common mode.